With the Tepas Perfo+ adapter plate system, workpieces and even small workpieces, can be fully cut through on large vacuum chucks on milling machines.
| Cookie | Duration | Description |
|---|---|---|
| Perfo+ vacuum adapter plates for large vacuum chucks |
Cutting through small workpieces on large (portal) milling machine!Both simple rectangular workpieces and workpieces with complex shapes can be machined. Also cutting through operations, such as slots and holes can be carried out by fully cutting through the workpiece on the Perfo+ adapter plate. On large milling machines with a large vacuum chuck, an MDF board is often used as an intermediate plate for cutting through workpieces. The main disadvantage of MDF, however, is that significant leakage occurs which means that a much lower vacuum is achieved and smaller workpieces are not held properly. With the Tepas Perfo+ system, very small workpieces from approx. 5 x 5 cm can be successfully held and even cut through. Tepas Perfo+ adapter plates are placed on existing vacuum chucks and work with the vacuum pump(s) that is/are already present, therefore the perfect solution is achieved with minimum investment. Field of application TP+ Surface machining  TP+ TPM+ of TPMS+ Simple outside contour  TP+ TPM+ of TPMS+ Complex outside contour  TP+ TPM+ of TPMS+ Cutting through operations
How it works The Tepas Perfo+ adapter plate is placed on top of the machine's existing vacuum chuck. The Perfo+ adapter plate is equipped with a PerfoMat+ vacuum mat.   How vacuum leakage is reduced:The workpieces to be machined are placed on the PerfoMat+ vacuum mats without using a sealing cord or similar, even if this does not seal the holes. The micro holes significantly reduce the leakage of exposed holes and the PerfoMat+ significantly increases the slip resistance, allowing workpieces to be reliably fully cut through.  Machining with emulsion:If the vacuum pump is fitted with a fluid separator, workpieces clamped with the Perfo+ adapter plates can be machined with emulsion or minimal lubrication. Clamping and positioningThe Tepas Perfo+ adapter plate is placed on top of the machine's existing vacuum chuck. With the sealing cord in the machine's vacuum chuck, a vacuum sealed zone is created which is as large as the dimensions of the Perfo+ adapter plate. The Perfo+ adapter plates are adapted to the dimensions of the machine's vacuum chuck.  The benefits
Dimensions |
